ABB ACS580 Firmware Manual page 20

16 Start-up, control with I/O and ID run
In an edit view:
• Use and
right.
• Use and
• Press (Save) to accept the new setting,
or press (Cancel) to go back to the
previous view without making changes.
To give the drive a name that will be shown at the
top, press .
If you do not want to change the default name
(ACS580), continue straight to the set-up of the
motor nominal values by pressing
Enter the name:
• To select the character mode (lower case /
upper case / numbers / special characters),
press until symbol
then select the mode with
can start adding characters. The mode remains
selected until you select another one.
• To add a character, highlight it with
and press .
• To remove a letter, press
• Press (Save) to accept the new setting,
or press (Cancel) to go back to the
previous view without making changes.
to move the cursor left and
to change the value.
(Next).
is highlighted and
and . Now you
and
.
,