ABB ACS580 Firmware Manual page 331

No. Name/Value
96.02 Pass code
0...99999999
96.03 Access level status
Bit Name
0 End user
1 Service
2 Advanced programmer
3...10 Reserved
11 OEM access level 1
12 OEM access level 2
13 OEM access level 3
14 Parameter lock
15 Reserved
0000b...0111b
96.04 Macro select
Done
ABB standard
Hand/Auto
Hand/PID
3-wire
Alternate
Motor
potentiometer
PID
Panel PID
PFC
Description
Pass codes can be entered into this parameter to activate
further access levels (see parameter
status) or to configure the user lock.
Entering "358" toggles the parameter lock, which prevents the
changing of all other parameters through the control panel or
the Drive composer PC tool.
Entering the user pass code (by default, "10000000") enables
parameters 96.100...96.102, which can be used to define a
new user pass code and to select the actions that are to be
prevented.
Entering an invalid pass code will close the user lock if open,
ie. hide parameters 96.100...96.102. After entering the code,
check that the parameters are in fact hidden.
Note: You must change the default user pass code to
maintain a high level of cybersecurity. Store the code in a safe
place – the protection cannot be disabled even by ABB if the
code is lost.
See also section User lock
Pass code.
Shows which access levels have been activated by pass
codes entered into parameter
Active access levels.
Selects the control macro. See chapter
59) for more information.
After a selection is made, the parameter reverts automatically
to Done.
Macro selection complete; normal operation.
Factory macro (see page 60). For scalar motor control.
Hand/Auto macro (see page 70).
Hand/PID macro (see page 72).
3-wire macro see page 60).
Alternate macro see page 66).
Motor potentiometer macro (see page 68).
PID macro (see page 74).
Panel PID macro (see page 76).
PFC macro (see page 78).
96.03 Access level
(page 140).
96.02 Pass code.
Control macros
Parameters 327
Def/FbEq16
0
-
0001b
-
(page Done
0
1
2
3
11
12
13
14
15
16