Parameters: 16-** Data Readouts - Danfoss VLT AutomationDrive FC 361 Programming Manual

Parameter Descriptions
15-50 SW ID Power Card
Range: Function:
0 [0 - 20 ] View the power card software
*
version number.
15-51 Frequency Converter Serial Number
Range: Function:
0 [0 - 10 ] View the frequency converter serial
*
number.
15-53 Power Card Serial Number
Range: Function:
0 [0 - 19 ] View the power card serial number.
*
15-54 Config File Name
Array [5]
Range: Function:
Size [0 - 16] Shows the special configuration
related filenames.
*
15-59 Filename
Range: Function:
Size [0 - 16] Shows the currently used customer-
related specific initial values (CSIV)
*
filename.
4.14.6 15-6* Option Ident.
This read-only parameter group contains information about
the hardware and software configuration of the options
installed in slots A, B, C0, and C1.
15-60 Option Mounted
Array [8]
Range: Function:
0 [0 - 30 ] Shows the type of the installed
*
option.
15-61 Option SW Version
Array [8]
Range: Function:
0 [0 - 20 ] View the installed option software
*
version.
15-62 Option Ordering No
Array [8]
Range: Function:
0 [0 - 8 ] Shows the ordering number for the
*
installed options.
MG06J202
Programming Guide
15-63 Option Serial No
Array [8]
Range:
0
*
4.14.7 15-8* Operating Data II
15-80 Fan Running Hours
Range:
0 h
*
15-81 Preset Fan Running Hours
Range:
0 h
*
4.14.8 15-9* Parameter Info
15-92 Defined Parameters
Range:
0
*
15-93 Modified Parameters
Range:
0
*

4.15 Parameters: 16-** Data Readouts

4.15.1 16-0* General Status
16-00 Control Word
Range:
0
*
Danfoss A/S © 03/2019 All rights reserved.
Function:
[0 - 18 ] View the installed option serial
number.
Function:
[0 - View how many hours the heat sink
2147483647 h] fan has run (increments for every
hour). The value is saved when the
frequency converter is turned off.
Function:
[0 - 99999 h] Enter the preset fan running hours
counter, see parameter 15-80 Fan
Running Hours.
This parameter cannot be selected
via the serial port, RS485.
Function:
[0 - 9999 ] View a list of all defined parameters
in the frequency converter. The list
ends with 0.
Function:
[0 - 9999 ] View a list of the parameters that
have been changed from their
default setting. The list ends with 0.
Changes may not be visible until
up to 30 s after implementation.
Function:
[0 - 65535 ] View the control word sent from
the frequency converter via the
serial communication port in hex
code.
4 4
143