Danfoss VLT AutomationDrive FC 361 Programming Manual page 53

Parameter Descriptions
3-01 Reference/Feedback Unit
Option: Function:
[172] in WG
[173] ft WG
[180] HP
3-02 Minimum Reference
Range: Function:
Size [ -999999.999 Enter the minimum reference. The
related - par. 3-03 minimum reference is the lowest
*
Reference- value obtainable by summing all
FeedbackUnit] references.
Minimum reference is active only
when parameter 3-00 Reference
Range is set to [0] Min.- Max.
The minimum reference unit
matches the unit selected in
parameter 3-01 Reference/Feedback
Unit.
3-03 Maximum Reference
Range: Function:
Size [ par. 3-02 - Enter the maximum reference. The
related 999999.999 maximum reference is the highest
*
Reference- value obtainable by summing all
FeedbackUnit] references.
The maximum reference unit
matches the unit selected in
parameter 3-00 Reference Range.
3-04 Reference Function
Option: Function:
[0] Sum Sums both external and preset
reference sources.
[1] External/Preset Use either the preset or the
external reference source.
Shift between external and preset
via a command or a digital input.
4.4.2 3-1* References
Select the preset references. Select Preset ref. bit 0/1/2 [16],
[17], or [18] for the corresponding digital inputs in
parameter group 5-1* Digital Inputs.
3-10 Preset Reference
Array [8]
Range: 0-7
Range: Function:
0 % [-100 - Enter up to 8 different preset
*
100 %] references (0–7) in this parameter,
using array programming. The
preset reference is stated as a
percentage of the value Ref
MG06J202
Programming Guide
3-10 Preset Reference
Array [8]
Range: 0-7
Range:
Preset
Illustration 4.14 Preset Reference
Preset ref. bit
Preset ref. 0
Preset ref. 1
Preset ref. 2
Preset ref. 3
Preset ref. 4
Preset ref. 5
Preset ref. 6
Preset ref. 7
Table 4.6 Preset Reference Bits
3-11 Jog Speed [Hz]
Range:
Size
related
*
MAX
Danfoss A/S © 03/2019 All rights reserved.
Function:
(parameter 3-03 Maximum
Reference). If a Ref
0 (parameter 3-02 Minimum
Reference) is programmed, the
preset reference is calculated as a
percentage of the full reference
range, that is on the basis of the
difference between Ref
Ref . Afterwards, the value is
MIN
added to Ref
MIN
references, select preset reference
bit 0/1/2 [16], [17] or [18] for the
corresponding digital inputs in
parameter group 5-1* Digital Inputs.
12 (+24V)
76543210
29
10101010 [P 5-13=Preset ref. bit 0]
32 [P 5-14=Preset ref. bit 1]
11001100
33
11110000 [P 5-15=Preset ref. bit 2]
2
0
0
0
0
1
1
1
1
Function:
[ 0 - par. 4-14 The jog speed is a fixed output
Hz] speed at which the frequency
converter is running when the jog
function is activated.
See also parameter 3-80 Jog Ramp
Time.
different from
MIN
4
and
MAX
. When using preset
1 0
0 0
0 1
1 0
1 1
0 0
0 1
1 0
1 1
51
4