Danfoss VLT AutomationDrive FC 361 Programming Manual page 112

Parameter Descriptions
9-63 Actual Baud Rate
Option:
[7] 3000 kbit/s
[8] 6000 kbit/s
[9] 12000 kbit/s
[10] 31,25 kbit/s
[11] 45,45 kbit/s
[255] No baudrate
*
4 4
found
9-64 Device Identification
Range:
0
*
9-65 Profile Number
Range:
0
*
9-67 Control Word 1
Range:
0
*
9-68 Status Word 1
Range:
0
*
9-70 Programming Set-up
This parameter is unique for LCP and fieldbus. See
parameter 0-11 Programming Set-up.
Option:
[0] Factory setup
[1] Set-up 1
[2] Set-up 2
[3] Set-up 3
[4] Set-up 4
[9] Active Set-up
*
110
Function:
Function:
[0 - 0 ] Device identification parameter.
Function:
[0 - 0 ] This parameter contains the profile
identification. Byte 1 contains the
profile number and byte 2 the
version number of the profile.
Function:
[0 - 65535 ] This parameter accepts the control
word from a master class 2 in the
same format as PCD 1.
Function:
[0 - 65535 ] This parameter delivers the status
word for a master class 2 in the
same format as PCD 2.
Function:
Select the set-up to edit.
Uses default data. This option can
be used as a data source to return
the other set-ups to a known state.
Edits set-up 1.
Edits set-up 2.
Edits set-up 3.
Edits set-up 4.
Follows the active set-up selected
in parameter 0-10 Active Set-up.
Danfoss A/S © 03/2019 All rights reserved.
VLT® AutomationDrive FC 361
9-71 Profibus Save Data Values
Option:
[0]
*
[1]
[2]
9-72 ProfibusDriveReset
Option:
[0]
*
[1]
[2]
[3]
9-75 DO Identification
Range:
0
*
9-80 Defined Parameters (1)
Array [116]
No LCP access
Read only
Range:
0
*
Function:
Parameter values changed via
PROFINET are not automatically
stored in the non-volatile memory.
Use this parameter to activate a
function that stores parameter
values in the EEPROM non-volatile
memory, so changed parameter
values are retained at power-down.
Off Deactivate the non-volatile storage
function.
Store all Store all parameter values for all
setups set-ups in the non-volatile memory.
When all parameter values have
been stored, the selection returns
to [0] Off.
Store all Store all parameter values for all
setups set-ups in the non-volatile memory.
When all parameter values have
been stored, the selection returns
to [0] Off.
Function:
No action
Power-on Reset frequency converter upon
reset power-up, as for power cycle.
Power-on Prepare for resetting frequency
reset prep converter upon power-up.
Comm option Reset the PROFINET option only,
reset the PROFINET option goes through
a power-up sequence.
When reset, the frequency
converter disappears from the
fieldbus, which may cause a
communication error from the
master.
Function:
[0 - 65535 ] Provides information about the DO
(Drive Object).
Function:
[0 - 9999 ] This parameter shows a list of all
the defined frequency converter
parameters available for PROFINET.
MG06J202