Chrysler PT Cruiser 2001 Service Manual Supplement page 1988

LEFT REAR SENSOR SIGNAL FAILURE —
TEST
3 Turn ignition off.
Inspect the Tone Wheel for damaged or missing teeth.
Note: The Tone Wheel Teeth should be perfectly square, not bent or nicked.
Is the Tone Wheel OK?
Yes → Go To 4
→ Replace the Tone Wheel.
No
4 Turn ignition off.
Inspect the Left Rear Wheel Speed Sensor and Connector.
Is the Sensor or Connector Damaged?
Yes → Repair as necessary.
→ Go To 5
No
5 Turn ignition off.
Inspect the Wheel Bearings for excessive runout or clearance.
Note: Refer to the appropriate service information, if necessary, for proce-
dures or specifications.
Is the Bearing Clearance OK?
Yes → Go To 6
→ Repair as necessary.
No
6 Turn ignition off.
Using a Feeler Gauge measure the Wheel Speed Sensor Air Gap.
Note: The Air Gap should be checked in at least Four places on the Tone
Wheel.
Is the Air Gap between 0.50 mm - 1.25 mm (0.019 - 0.049 )?
Yes → Go To 7
→ Repair as necessary.
No
7 Turn ignition off.
Disconnect the Left Rear Wheel Speed Sensor Connector.
Note: Check connector - Clean/repair as necessary.
Connect a single jumper wire from the harness side of Left Rear Wheel Speed Sensor
12 Volt Supply Circuit into the Left Rear Wheel Speed Sensor connector mating
terminal.
Using a voltmeter in Direct Current (DC) mode, measure the Left Rear Wheel Speed
Sensor Signal Circuit at Left Rear Wheel Speed Sensor conector.
Turn ignition on.
Slowly rotate the wheel while observing voltmeter reading.
Does the voltage change from approximately 1.6 volts to 0.8 volts as the wheel is
rotated?
Yes → Go To 8
→ Replace the Left Rear Wheel Speed Sensor.
No
ACTION
Perform ABS VERIFICATION TEST.
Perform ABS VERIFICATION TEST.
Perform ABS VERIFICATION TEST.
Perform ABS VERIFICATION TEST.
Perform ABS VERIFICATION TEST.
Continued
31
BRAKES (CAB)
APPLICABILITY
All
All
All
All
All