Chrysler PT Cruiser 2001 Service Manual Supplement page 1986

LEFT REAR SENSOR CIRCUIT FAILURE —
TEST
15 Turn ignition off.
Disconnect the Left Rear Wheel Speed Sensor connector.
Note: Check connector - Clean/repair as necessary.
Turn ignition on.
Using a test light connected to 12 volts, probe the Left Rear Wheel Speed Sensor 12
Volt Supply Circuit.
Is the test light on?
Yes → Replace the CAB.
→ Go To 16
No
16 Turn ignition off.
Disconnect the Left Rear Wheel Speed Sensor connector.
Note: Check connector - Clean/repair as necessary.
Turn ignition on.
Using a test light connected to 12 volts, probe the Left Rear Wheel Speed Sensor
Signal Circuit.
Is the test light on?
Yes → Replace the CAB.
→ Test Complete.
No
17 Turn ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
Yes → Test Complete.
→ Test Complete.
No
ACTION
Perform ABS VERIFICATION TEST.
Perform ABS VERIFICATION TEST.
Continued
29
BRAKES (CAB)
APPLICABILITY
All
All
All