Chrysler PT Cruiser 2001 Service Manual Supplement page 1999

BRAKES (CAB)
RIGHT FRONT SENSOR CIRCUIT FAILURE —
TEST
14 Turn ignition off.
Disconnect the Right Front Wheel Speed Sensor connector.
Note: Check connector - Clean/repair as necessary.
Turn ignition on.
Using a test light connected to 12 volts, probe the Right Front Wheel Speed Sensor
Signal Circuit.
Is the test light on?
Yes → Go To 15
No
15 Turn ignition off.
Disconnect the Right Front Wheel Speed Sensor connector.
Note: Check connector - Clean/repair as necessary.
Turn ignition on.
Using a test light connected to 12 volts, probe the Right Front Wheel Speed Sensor
12 Volt Supply Circuit.
Is the test light on?
Yes → Replace the CAB.
No
16 Turn ignition off.
Disconnect the Right Front Wheel Speed Sensor connector.
Note: Check connector - Clean/repair as necessary.
Turn ignition on.
Using a test light connected to 12 volts, probe the Right Front Wheel Speed Sensor
Signal Circuit.
Is the test light on?
Yes → Replace the CAB.
No
17 Turn ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
Yes → Test Complete.
No
ACTION
→ Replace the CAB.
Perform ABS VERIFICATION TEST.
Perform ABS VERIFICATION TEST.
→ Go To 16
Perform ABS VERIFICATION TEST.
→ Test Complete.
→ Test Complete.
Continued
42
APPLICABILITY
All
All
All
All