Chrysler PT Cruiser 2001 Service Manual Supplement page 2014

SYSTEM UNDERVOLTAGE —
TEST
3 Turn ignition off.
Disconnect the CAB connector.
Note: Check connector - Clean/repair as necessary.
Start the engine.
Raise engine RPM's above 1800.
Measure the voltage of the Fused Ignition Switch Output circuit.
Is the voltage below 13 volts ?
Yes → Refer to appropriate service information for charging system
→ Test Complete.
No
4 Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
Continued
ACTION
testing and repair.
Perform ABS VERIFICATION TEST.
Perform ABS VERIFICATION TEST.
57
BRAKES (CAB)
APPLICABILITY
All
All