Subaru Impreza 2002 Service Manual page 4122

(4) Apply grease to the specified points.
• Spline FX2200
• Shaft SUNLIGHT 2
(A) Spline (FX2200)
(B) Shaft (SUNLIGHT 2)
(5) Insert the release fork shaft into release
fork.
CAUTION:
Be sure to fit groove on clutch release lever
shaft into pin located at through-hole.
(A) Release fork
(B) Release shaft
(C) Spring pin
ENGINE ASSEMBLY
(6) Tighten the plug.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb)
2) Install the front cushion rubbers to engine.
Tightening torque:
34 N·m (3.5 kgf-m, 25.3 ft-lb)
3) Install the engine onto transmission.
(1) Position the engine in engine compartment
and align it with transmission.
CAUTION:
Be careful not to damage adjacent parts or
body panels with crank pulley, oil pressure
gauge, etc.
(2) Apply a small amount of grease to splines of
mainshaft.
4) Tighten the bolt which holds right upper side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
5) Remove the lifting device and wire ropes.
ME(STi)-37
MECHANICAL