Subaru Impreza 2002 Service Manual page 4129

MECHANICAL
2. REAR SIDE BELT
1) Install the rear side belt, and tighten the slider
bolt (B) so as to obtain the specified belt tension.
<Ref. to ME(STi)-44, INSPECTION, V-belt.>
2) Tighten the lock nut (A).
Tightening torque:
Lock nut (A);
22.6 N·m (2.3 kgf-m, 16.6 ft-lb)
C: INSPECTION
1) Replace the belts, if cracks, fraying or wear is
found.
2) Check the drive belt tension and adjust it if nec-
essary by changing generator installing position
and/or idler pulley installing position.
Belt tension
(A)
replaced: 7 — 9 mm (0.276 — 0.354 in)
reused: 9 — 11 mm (0.354 — 0.433 in)
(B)*
replaced: 7.5 — 8.5 mm (0.295 — 0.335 in)
reused: 9.0 — 10.0 mm (0.354 — 0.394 in)
*: With Air conditioner
98 N (10 kgf, 22 lb)
C/P Crankshaft pulley
GEN Generator
P/S Power steering oil pump pulley
A/C Air conditioning compressor pulley
I/P Idler pulley
V-BELT
(B)
(A)
EN0226
EN1520
ME(STi)-44