Subaru Impreza 2002 Service Manual page 2560

10) Depress the clutch pedal, then disconnect the
clutch cable from clutch pedal. (1.6 L model)
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
• If the cable clamp is damaged, replace it with
a new one.
• Never fail to cover the outer cable end with
boot.
• Be careful not to kink the accelerator cable.
• Always use new clevis pins.
2) Adjust the clutch pedal after installation. <Ref. to
CL-46, ADJUSTMENT, Clutch Pedal.>
C: DISASSEMBLY
1. LHD MODEL
• Except 1.6 L MODEL
1) Remove the clips, assist spring, rod and bush-
ing.
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
2) Remove the spring pin and lever.
(A) Pin
(B) Lever
CLUTCH PEDAL
3) Remove the clutch pedal and bushings.
4) Remove the stopper, clip, O-ring, rod S, and
then remove the spring and bushing S.
B2M4115A
5) Remove the stoppers from clutch pedal.
6) Remove the clutch pedal pad. (Non-turbo mod-
el)
B2M4116A
CL-43
(A) Clutch pedal
(B) Bushing
(A) Clip
(B) O-ring
(C) Bushing S
(D) Spring S
(E) Rod S
(F) Stopper
CLUTCH SYSTEM
B2M4117A
B2M4118A