Toyota Camry Manual page 634

BO–68
Motor Housing
Pointer (Grey) Gear Pointer (Brown)
BODY
ADJUSTMENT
1.
NOTICE:
The "O" position is the same as the sliding roof "flush "
position (sliding roof closed).
Use the vehicle sliding roof switch or a hex wrench to align the
gear pointer with the motor housing pointer as shown.
H01817
NOTICE:
Use only the sliding roof switch to electrically operate the
motor or sliding roof. Do not use any other electrical
source to power the motor. If the sliding roof switch (under
vehicle power) is not available, use a hex wrench to align
the motor pointers.
2.
H01818
3.
(a)
HINT:
At the time of installation, please refer to the following item.
Adjust the height of the glass panel, then tighten the 4 screws.
(b)
H01819
4.
(a)
(b)
HINT:
Using a screwdriver, move the LH and RH cable assemblies for-
ward and backward to align the holes in the cable arm and lifter
arm.
(c)
HINT:
Verify the cam block alignment hole is aligned with the lift arm
Parts shown
alignment hole. Misalignment at this point will result in a mal-
disassembled
for clarity function of the sliding roof mechanism.
5.
HINT:
Before reinstalling the drive gear assembly, double check the
alignment of the gear pointers.
H01820
– SLIDING ROOF (TMMK Made)
ALIGN THE MOTOR TO "O" POSITION
REMOVE DRIVE GEAR ASSEMBLY
REMOVE GLASS PANEL
Remove the 4 glass panels adjustment screws.
Pull the glass upward to remove it.
ALIGN SLIDING ROOF COMPONENTS
Verify the hook appears as shown.
Align the cable arm hole with the lift arm hole.
Temporarily insert a 3 mm (0.12 in.) pin through the align-
ment holes in the cable arm and lifter arm.
REINSTALL DRIVE GEAR ASSEMBLY
Author :
BO0LY–01
Date :
2416