Toyota Camry Manual page 772

3 2
Front door
Rear door
Rear door
Front door
Rear door
Front door
Rear door
Front door
BODY ELECTRICAL
6.
3 2
(a)
(b)
If operation is not as specified, replace the door lock assembly.
N20570
7.
(a)
(b)
N20571
(c)
(d)
If operation is not as specified, replace the door lock assembly.
N20572
8.
(a)
(b)
N20573
(c)
(d)
If operation is not as specified, replace the door lock assembly.
N20572
– POWER DOOR LOCK CONTROL SYSTEM
INSPECT MOTOR OPERATION
Connect the positive (+) lead from the battery to terminal
3 and the negative (–) lead to terminal 2, and check that
the door lock link moves to UNLOCK position.
Remove the polarity and check that the door lock link
moves to LOCK position.
Using an ammeter:
INSPECT PTC THERMISTOR OPERATION
Connect the positive (+) lead from the battery to terminal
3.
Connect the positive (+) lead from the ammeter to termi-
nal 2 and the negative (–) lead to battery negative (–) ter-
minal, and check that the current changes from approxi-
mately 3.2 A to less than 0.5 A within 20 to 70 seconds.
Disconnect the leads from terminals.
Approximately 60 seconds later, connect the positive (+)
lead from the battery to terminal 2 and the negative (–)
lead to terminal 3, and check that the door lock moves to
the LOCK position.
Using an ammeter with a current–measuring probe:
INSPECT PTC THERMISTOR OPERATION
Connect the positive (+) lead from the battery to terminal
3 and the negative (–) lead to terminal 2.
Attach a current–measuring probe to either the positive
(+) lead or the negative (–) lead, and check that the cur-
rent changes from approximately 3.2 A to less than 0.5 A
within 20 to 70 seconds.
Disconnect the leads from terminals.
Approximately 60 seconds later, reverse the polarity, and
check that the door lock moves to the LOCK position.
Author :
BE–71
Date :
2291