Toyota Camry Manual page 767

BE–66
BODY ELECTRICAL
11.
1
2
(a)
(b)
(c)
I21314
(d)
(e)
(f)
If operation is not as specified, replace the motor.
2
1
I21315
12.
2 1
(a)
(b)
(c)
I21312
(d)
(e)
– POWER WINDOW CONTROL SYSTEM
Driver's door:
INSPECT POWER WINDOW MOTOR PTC THERM-
ISTOR OPERATION
Disconnect the connector from the master switch.
Connect the positive (+) lead from the ammeter to termi-
nal 2 on the wire harness side connector and the negative
(–) lead to negative terminal of the battery.
Connect the positive (+) lead from the battery to terminal
1 on the wire harness side connector, and raise the win-
dow to the fully position.
Continue to apply voltage and check that the current
changes to less than 1 A within 4 to 90 seconds.
Disconnect the leads from the terminals.
Approximately 60 seconds later, connect the positive (+)
lead from the battery to terminal 2 and the negative (–)
lead to terminal 1, and check that the window begins to
descend.
Passenger 's door:
INSPECT POWER WINDOW MOTOR PTC THERM-
ISTOR OPERATION
Disconnect the connector from the power window switch.
Connect the positive (+) lead from the ammeter to termi-
nal 1 on the wire harness side connector and the negative
(–) lead to negative terminal of the battery.
Connect the positive (+) lead from the battery to terminal
2 on the wire harness side connector, and raise the win-
dow to the fully position.
Continue to apply voltage and check that the current
changes to less than 1 A within 4 to 90 seconds.
Disconnect the leads from the terminals.
Author : MH Date : 3/7/02
2286