BODY
–
SLIDING ROOF (TMC Made)
ADJUSTMENT
1.
REMOVE SIDE GARNISH
Before making adjustments, using a screwdriver, remove the
side garnishes.
HINT:
z
Tape the screwdriver tip before use.
z
After adjustment, reinstall the side garnishes.
N21422
2.
TO ADJUST FORWARD OR REARWARD
(a)
Using a torx wrench, loosening the sliding roof glass
installation screws.
(b)
Adjust the sliding roof glass forward and rearward.
Z04207
3.
TO ADJUST CLEARANCE
(Difference in left and right clearance)
(a)
When the front or rear alignment is not correct, remove
the drive gear and sliding roof glass, then adjust the drive
rail.
NOTICE:
Remove the drive gear with sliding roof is full closed.
BO3396
(b)
Adjust by slide the cable forward or rearward to align the
2 marks as shown.
(c)
Install the drive gear and sliding roof glass.
N21525
Author :
Date :
BO–59
BO0M5–01
2407