Toyota Camry Manual page 339

COMPONENT PARTS INSTALLATION
COMPONENT PARTS INSTALLATION
Disassembly, inspection and assembly of each component group have been indicated in the preceding
chapter. Before assembly, make sure, again, that all component groups are assembled correctly.
If something wrong is found in a certain component group during assembly, inspect and repair this
group immediately.
Recommended ATF:
DEXRON ® @@@@@: [g 2]
GENERAL INSTALLATION NOTES:
1. The automatic transaxle is composed of highly precision–finished parts, necessitating careful inspec-
tion before assembly because even a small nick could cause fluid leakage and affect performance.
2. Before assembling new clutch discs, soak them in automatic transaxle fluid for at least 15 minutes.
3. Apply automatic transaxle fluid on the sliding or rotating surfaces of parts before assembly.
4. Use petroleum jelly to keep small parts in their places.
5. Do not use adhesive cements on gaskets and similar parts.
6. When assembling the transaxle, be sure to use new gaskets and O–rings.
7. Dry all parts with compressed air–never use shop rags.
8. Be sure to install the thrust bearings and races in the correct direction and position.
AUTOMATIC TRANSAXLE – COMPONENT PARTS INSTALLATION
AX–99
AX0GW–02