Toyota Camry Manual page 473

AX–70
AUTOMATIC TRANSAXLE
COUNTER DRIVE GEAR ASSEMBLY
1. INSTALL SNAP RING INTO COUNTER GEAR
Install the snap ring with a screwdriver.
2. INSTALL OUTER RACES INTO COUNTER DRIVE
GEAR
Using SST, press in the 2 outer races to both sides of the
gear.
SST 09350–32014 (09351–32120, 09351–32150)
HINT: Press in the 2 outer races until they touch the snap
ring. Tap the races in straight, so that they do not tilt.
3. INSTALL OVERDRIVE PLANETARY RING GEAR INTO
COUNTER DRIVE GEAR
(a) Install the snap ring to the ring gear.
(b) While pushing down the ring gear, squeeze the snap ring
end with needle–nose pliers, and install it into the groove.
4. INSTALL REAR BEARING
Using SST, press in the bearing onto the shaft.
SST 09350–32014 (09351–32120)
HINT: Press in the bearing until the side surface of the in-
ner race touches the planetary carrier.
– OVERDRIVE UNIT
AX040–03