Toyota Camry Manual page 841

BR–12
Soft Jows
BRAKE
DISASSEMBLY
1.
(a)
(b)
2.
3.
4.
Soft Jows
Using a screwdriver, push the pistons in all the way and remove
the piston stopper bolt and gasket.
HINT:
Tape the screwdriver tip before use.
R11406
5.
(a)
HINT:
Tape the screwdriver tip before use.
(b)
NOTICE:
R11407
S
S
(c)
HINT:
Make sure that the distance (A) from the rag to the top of the
blocks is at least 100 mm (3.94 in.).
A
R12236
– BRAKE MASTER CYLINDER
REMOVE RESERVOIR
Remove the set screw and pull out the reservoir.
Torque: 1.7 N·m (18 kgf·cm, 16 in.·lbf)
Remove the cap and strainer from the reservoir.
REMOVE 2 GROMMETS
Except w/ TRAC:
PLACE CYLINDER IN VISE
w/o TRAC:
REMOVE PISTON STOPPER BOLT
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
w/o TRAC:
REMOVE 2 PISTONS AND SPRINGS
Push in the piston with a screwdriver and remove the
snap ring with snap ring pliers.
Remove the No. 1 piston and spring by hand, pulling
straight out, not at an angle.
If pulled out and installed at an angle, there is a possi-
bility that the cylinder bore could be damaged.
At the time of reassembly, please refer to the follow-
ing item.
Be careful not to damage the rubber lips on the pis-
tons.
Place a rag and 2 wooden blocks on the work table, and
lightly tap the cylinder flange against the block edges until
the No. 2 piston drops out of the cylinder.
Author :
BR0AG–02
Date :
2035