Toyota Camry Manual page 278

AX–38
AUTOMATIC TRANSAXLE
Drive and driven gear thickness
If the thickest gear cannot make the side clearance within
standard specification, replace the oil pump body subas-
sembly.
4. CHECK OIL PUMP BODY BUSHING
Using a dial indicator, measure the inside diameter of the
oil pump body bushing.
Maximum inside diameter:
If the inside diameter is greater than the maximum, re-
place the oil pump body subassembly.
5. CHECK STATOR SHAFT BUSHINGS
Using a dial indicator, measure the inside diameter of the
stator shaft bushings.
Maximum inside diameter:
If the inside diameter is greater than the maximum, re-
place the stator shaft.
OIL PUMP ASSEMBLY
1. INSTALL FRONT OIL SEAL
Using SST and a hammer, install a new oil seal. The seal
end should be flush with the outer edge of the pump body.
SST 09350–32014 (09351–32140)
2. INSTALL DRIVEN GEAR AND DRIVE GEAR
Make sure the top of the gears are facing upward.
– OIL PUMP
Mark
mm (in.)
A
B
C
38.18 mm (1.5031 in.)
Front side
21.57 mm (0.8492 in.)
Rear side
27.07 mm (1.0657 in.)
9.440 – 9.456 (0.3717 – 0.3723)
9.456 – 9.474 (0.3723 – 0.3730)
9.474 – 9.490 (0.3730 – 0.3736)
Thickness
AX0F6–02