Toyota Camry Manual page 628

BO–62
Level Difference ± 1.5 mm
Glass Panel
Weatherstrip
BODY
SLIDING ROOF (TMMK Made)
ON–VEHICLE INSPECTION
INSPECT SLIDING ROOF GLASS ALIGNMENT
(a) Start the engine and check the operation time of the slid-
ing roof.
Operation time:
Approximately 6 sec.
(b) Check for abnormal noise or binding during operation.
H01814
(c) Check for water leakage with the sliding roof fully closed.
(d) Check the alignment between the sliding roof weather-
strip and the roof panel.
All sides:
0 ± 1.5 mm (0 ± 0.059 in.)
HINT:
At the time of installation, please refer to the following item.
To align the glass to the roof surface, loosen the 4 screws, then
Roof Panel
adjust and retighten.
If the sliding roof does not operate:
H01815
(e) Remove the map light assembly.
(f) Manually operate the sliding roof by inserting a hex
wrench into the motor to turn the drive shaft.
H01816
– SLIDING ROOF (TMMK Made)
Author :
BO0LU–01
Date :
2410