Toyota Camry Manual page 464

AUTOMATIC TRANSAXLE
OVERDRIVE BRAKE INSPECTION
INSPECT DISCS, PLATES AND FLANGE
Check if the sliding surfaces of the discs, plates and
flange are worn or burnt. If necessary, replace them.
HINT:
S
S
OVERDRIVE DIRECT CLUTCH
DISASSEMBLY
1. CHECK PISTON STROKE OF DIRECT CLUTCH
Install a dial indicator and measuring terminal (SST) to-
gether, measure the piston stroke while applying and re-
leasing compressed air (392–785 kPa, 5–8 kgf/cm
57–114 psi).
Piston stroke:
SST 09350–32014 (09351–32190)
If the piston stroke is greater than the maximum, inspect
each component.
2. REMOVE OVERDRIVE DIRECT CLUTCH FROM CASE
3. REMOVE BEARING AND RACE FROM CLUTCH
DRUM AND CASE
– OVERDRIVE UNIT
If the lining of the disc is peeling off or discolored, or
even if a part of the printed numbers are defaced, re-
place all discs.
Before assembling new discs, soak them in ATF for
at least 15 minutes.
1.75–2.49 mm (0.0689–0.0980 in.)
AX–61
AX03U–03
AX03V–05
2
,