Toyota Camry Manual page 852

BRAKE – FRONT BRAKE PAD
(a) 1MZ–FE engine:
Install a pad wear indicator plate on the inner pad.
(b) Apply disc brake grease to both sides of the inner anti–
squeal shims (See page BR–21).
(c) Install the 2 anti–squeal shims on each pad.
(d) Install inner pad with the pad wear indicator plate facing
upward.
(e) Install inner pad.
(f) Install outer pad.
R00595
NOTICE:
There should be no oil or grease adhering to the friction
surfaces of the pads or the disc.
(g) 5S–FE engine:
Install the 2 anti–squeal springs.
13. INSTALL CALIPER
(a) Draw out a small amount of brake fluid from the reservoir.
(b) Press in the piston with a hammer handle or similar imple-
ment.
HINT:
If the piston is difficult to push in, loosen the bleeder plug and
push in the piston while letting some brake fluid escape.
(c) Install the caliper.
(d) 5S–FE engine:
R02981
Hold the sliding pin and torque the installation bolt.
(e) 1MZ–FE engine:
Install the installation bolt.
Torque: 34 N·m (350 kgf·cm, 25 ft·lbf)
(f) Install the flexible hose and bolt to the bracket.
Torque: 29 N·m (300 kgf·cm, 21 ft·lbf)
14. INSTALL FRONT WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
15. DEPRESS BRAKE PEDAL SEVERAL TIMES
16. CHECK THAT FLUID LEVEL IS AT MAX LINE
Author : Date :
BR–23
2046