Toyota Camry Manual page 606

BO–40
BODY – BODY OUTSIDE MOULDING
REMOVAL
CAUTION:
z
Store in a cool place, avoiding direct sunlight, high
temperature and dust.
z
The moulding is made of polyvinyl chloride. Do not al-
low this material to come in contact with thinner or
other solvents, open flame or boiling water.
z
The storage time for the moulding and adhesive is
limited to about 9 months.
1. REMOVE ENDS OF MOULDING
Using a scraper, pry the moulding loose about 30 mm (1.18 in.)
form each end.
HINT:
Tape the scraper tip before using.
H01782
2. REMOVE MOULDING AND ADHESIVE
(a) Pull off the moulding by cutting the adhesive with a knife.
(b) Scrape off adhesive from the body with sandpaper cutter.
NOTICE:
z
Remember that 30 – 80 mm (1.18 – 3.15 in.) of the ends
of the moulding are glued tightly with a strong adhe-
sive.
z
Do not reuse moulding.
H01783
Author : Date :
BO0M9–01
2388