Toyota Camry Manual page 442

AUTOMATIC TRANSAXLE
3. CHECK SIDE CLEARANCE OF BOTH GEARS
Using a steel straightedge and feeler gauge, measure the
side clearance of both gears.
Standard side clearance:
Maximum side clearance:
There are 3 different thicknesses for drive and driven
gears.
Drive and driven gear thickness
If the thickest gear can not make the side clearance within
standard specification, replace the oil pump body subas-
sembly.
4. CHECK OIL PUMP BODY BUSHING
Using a dial indicator, measure the inside diameter of the
oil pump body bushing.
Maximum inside diameter:
If the inside diameter is greater than the maximum, re-
place the oil pump body subassembly.
5. CHECK STATOR SHAFT BUSHING
Using a dial indicator, measure the inside diameter stator
shaft bushing.
Maximum inside diameter:
If the inside diameter is greater than the maximum, re-
place the stator shaft.
OIL PUMP ASSEMBLY
1. INSTALL FRONT OIL SEAL
Using SST and a hammer, install a new oil seal. The seal
end should be flush with the outer edge of the pump body.
SST 09350–32014 (09351–32140)
– OIL PUMP
0.002–0.005 mm (0.0008–0.0020 in.)
0.100 mm (0.0039 in.)
Mark
A
B
C
38.18 mm (1.5031 in.)
21.57 mm (0.8492 in.)
Thickness mm (in.)
9.440–9.456 (0.3717–0.3723)
9.456–9.474 (0.3723–0.3730)
9.474–9.490 (0.3730–0.3736)
AX–39
AX031–02