Toyota Camry Manual page 505

AX–102
AUTOMATIC TRANSAXLE
DIFFERENTIAL AND DRIVE PINION
INSTALLATION
1. INSTALL DRIVE PINION INTO TRANSAXLE CASE
(a) Using SST, install the bearing to the drive pinion shaft.
SST 09350–32014 (09351–32120)
(b) Place the bearing cage onto the drive pinion shaft.
NOTICE: Be careful not to damage the oil seals with the
pinion shaft.
(c) Using a brass bar and hammer, slightly tap the bearing
cage into the transaxle case until the snap ring groove in
the bore can be seen.
(d) Using SST, install snap ring into the bore.
SST 09350–32014 (09351–32050)
(e) Using SST, install the snap ring.
SST 09350–32014 (09351–32050)
– COMPONENT PARTS INSTALLATION
AX0U1–02