Toyota Camry Manual page 508

AUTOMATIC TRANSAXLE
9. INSTALL CARRIER COVER
(a) Remove any packing material and be careful not to drop
oil on the contacting surfaces of the carrier cover and
transaxle case.
(b) Apply seal packing to the carrier cover.
Seal packing:
HINT: Install the carrier cover within 10 minutes after ap-
plying seal packing.
(c) Install and torque the 11 bolts.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
HINT: Each bolt length is indicated below.
Bolt length:
10. ADJUST SIDE BEARING PRELOAD
(a) Remove any packing material on the contacting surfaces
of the LH bearing retainer and transaxle case.
HINT: Do not apply seal packing yet.
(b) Install the LH bearing retainer and torque the 6 bolts.
Torque: 19 N·m (195 kgf·cm, 14 ft·lbf)
(c) Snap down the bearings by turning the differential case
several times.
(d) Using a small torque wrench, measure the differential to-
tal preload.
Total preload (at starting):
New bearing
Drive pinion preload plus 0.2–0.4 N·m
Reused bearing
Drive pinion preload plus 0.1–0.2 N·m
If the preload is not within specification, replace the ad-
justing shim in the LH bearing retainer with one of a differ-
ent thickness.
– COMPONENT PARTS INSTALLATION
Part No.08826–00090, THREE BOND 1281 or equiva-
lent
Bolt A: 100 mm (3.937 in.)
Bolt B: 65 mm (2.559 in.)
Bolt C: 75 mm (2.953 in.)
(2.5–5.1 kgf·cm, 2.2–3.6 in.·lbf)
(1.3–2.0 kgf·cm, 1.1–1.7 in.·lbf)
AX–105