Toyota Camry Manual page 764

Wire harness side:
1 2 3
7 8 9 10 11 12 13 14
e–14–1–A
Tester connection
4 – Ground
8 – Ground
8 – Ground
1 2
5
3
BODY ELECTRICAL
4 5 6
Z05742
Constant
Ignition switch position LOCK or ACC
Ignition switch position ON
5 4 3 2 1
N20560
5 4 3 2 1
N20561
3 5
1 2
N14863
– POWER WINDOW CONTROL SYSTEM
5. INSPECT POWER WINDOW MASTER SWITCH CIR-
CUIT
Disconnect the connector from the master switch and inspect
the connector on the wire harness side, as shown in the follow-
ing page.
Condition
*Exceptions: During 60 seconds after the ignition switch is
turned ON to OFF (ACC) or until driver or a passenger's door
is opened after the ignition switch is turned ON to OFF (ACC).
If the circuit is not as specified, inspect the circuits connected
to other parts.
6. Front passenger's door:
INSPECT POWER WINDOW SWITCH CONTINUITY
Switch position
UP
OFF
DOWN
If continuity is not as specified, replace the switch.
7. Rear door:
INSPECT POWER WINDOW SWITCH CONTINUITY
Switch position
UP
OFF
DOWN
If continuity is not as specified, replace the switch.
8. INSPECT POWER MAIN RELAY CONTINUITY
Condition
Constant
Apply B+ between
terminals 1 and 2.
If continuity is not as specified, replace the relay.
Author :
Specified condition
Continuity
*No voltage
Battery positive voltage
Tester connection Specified condition
1 – 2, 3 – 4 Continuity
1 – 2, 3 – 5 Continuity
1 – 4, 3 – 5 Continuity
Tester connection Specified condition
1 – 3, 4 – 5 Continuity
1 – 2, 4 – 5 Continuity
1 – 2, 3 – 5 Continuity
Tester connection Specified condition
1 – 2 Continuity
3 – 5 Continuity
Date :
BE–63
2283