Automatic Transmission Specifications; Parts To Be Replaced (After Removal); Consumables - Renault Clio Workshop Repair Manual

R R R R E E E E P P P P L L L L A A A A C C C C E E E E M M M M E E E E N N N N T T T T I I I I N N N N S S S S T T T T R R R R U U U U C C C C T T T T I I I I O O O O N N N N S S S S
• Damaged brakes or clutch:
st
1 possibility:
Repair the gear section and clean the final drive,
oil cooler, converter* and check the hydraulic dis-
tributor.
nd
2 possibility:
Change the gear section alone. (Adjust the end
float and the oil pressure setting). Or change the
entire automatic transmission (service exchange
or new transmission).
* The cleaning method is given in the "Torque
converter" section.
- roll pins,
- O and square section seals,
- lip seals,
- paper seals,
- bearings (if they have had to be removed),
- circlips,
- differential bank (MJ),
Name
LOCTITE FORMAJOINT
LOCTITE FRENETANCH
LOCTITE SCELBLOC
Transmission oil
ELF RENAULTMATIC D2 or
MOBIL ATF 220
Final drive oil
SAE 80 W or 75 W
AUTOMATIC TRANSMISSION
Specifications

Parts to be replaced (after removal)

Consumables

• Bearing(s) which is/are noisy but not broken:
Change the bearing(s) and the filter.
• Bearing(s) or other mechanical component
damaged:
If the damage is extensive, change the automatic
transmission (service exchange or new transmis-
sion).
For a service exchange:
Return the worn transmission with the packaging
in which the new part was delivered.
- speedometer drive shaft (MB),
- speedometer drive gears (if they have had to
be removed),
- the entire free wheel (if there is a problem),
- the quadrants with the drive hub (if they are
seized in the hub).
Packaging
50 ml bottle
24 ml bottle
24 ml bottle
23-13
To be used for:
Housing joint faces
1 drop on converter drive plate
bolt at crankshaft end.
1 drop on converter seal (MB).
Immersion of all parts before
assembly (except those for ML
final drive).
Immersion of final drive
components (ML).
23