Performing The Acceptance Test (Example) - Siemens SINAMICS S120 Function Manual

Acceptance test
7.3 Acceptance test with Startdrive
Resetting test results
1. Click the "Reset test results" button to delete all the results of the tests previously
performed for this drive.
This restores the initial state from which you can perform the acceptance tests again.
7.3.3

Performing the acceptance test (example)

Description
After accepting the function selection in the "Preparing the acceptance test (Page 345)" step,
the functions to be tested are displayed in the secondary navigation.
You can now perform the tests from top to bottom or in any required sequence.
The status of the individual tests is represented as follows:
● Blue: The test is initial and has not yet been tested.
● Green: The test was performed successfully.
● Red: The test was aborted with error. The test can be repeated by reselecting the
function.
Structure of the acceptance test wizards
The listed wizards have the same structure for every acceptance test.
The upper area contains the workflow that represents the individual test steps and their
status.
The states have the following meaning:
● Blue: Active test step.
● Green: Test step completed.
The instructions for the test steps are displayed in the area below the workflow. The test
steps must be performed by the user. After performing the instructions, click "Next" to
advance to the next step. At the end, the test is completed by clicking "Finish". The status of
this test is then updated in the secondary navigation.
The operator controls for the test steps are located in the lower area. This includes, for
example, the control panel for traversing the axis to be tested.
Starting and performing the acceptance test
1. Click one of the functions to be tested (SS1 in this case).
The wizard is started in the working area.
2. Enter a test designation. This designation also appears later in the acceptance report.
346
Function Manual, 12/2018, 6SL3097-5AR00-0BP1
Safety Integrated