6.11
PROFIsafe communication
Requirements for PROFIsafe communication
The following minimum software and hardware requirements apply for the configuration and
operation of safety-oriented communication (F communication):
Software:
Hardware:
When using a SIMATIC F-CPU
1)
As an alternative to Drive ES Basic, you can commission the communication using the GSD file.
2)
Note
Required software or hardware components
If a single software or hardware component is either older than those specified in this
document or is missing, PROFIsafe can no longer be configured via PROFIBUS or
PROFINET.
6.11.1
PROFIsafe via PROFIBUS
Note
Startdrive
Please note that you cannot yet use this function with Startdrive.
You can find information on how to commission this function with STARTER in older editions
of this manual.
Safety Integrated
Function Manual, 12/2018, 6SL3097-5AR00-0BP1
SIMATIC Manager STEP 7 V5.5 SP1 or higher
•
S7 F Configuration Pack V5.5 SP5
•
S7 Distributed Safety Programming V5.4 SP5
•
Startdrive V15 SP1
•
Drive ES Basic V5.4 SP4
•
Correct installation of the software
•
A control with safety functions (in our example, SIMATIC F-CPU 317F-2)
•
SINAMICS S120 (in our example, a CU320-2)
•
Correct installation of the devices
•
or higher
1)
or higher
1)
or higher
1)
2)
Commissioning
6.11 PROFIsafe communication
321