Contents And Depth Of The Acceptance Test; Content Of The Complete Acceptance Test - Siemens SINAMICS S120 Function Manual

Acceptance test

7.2 Contents and depth of the acceptance test

7.2 Contents and depth of the acceptance test
7.2.1

Content of the complete acceptance test

A) Documentation
Documentation of the machine and of safety functions
● Machine description (with overview)
● Specification of the controller (if this exists)
● Function table:
– Active monitoring functions depending on the operating mode and the protective door
– Other sensors with protective functions
– The table is part or is the result of the configuring work.
● SI functions for each drive
● Information about safety equipment
B) Function test diagnostic/safety functions
Detailed function test and evaluation of SI functions used. For some functions, trace
recordings of individual parameters can be used.
The Acceptance test wizard (Page 344) in Startdrive supports you with these actions.
● Encoder parameterization test
– Required when using the Extended/Advanced Functions with encoder
– Only required at an encoder replacement
● Test of the SI function "Safe Torque Off" (STO)
– Required when used in Basic and/or Extended Functions
● Test of the SI function "Safe Stop 1" (SS1)
– Required when used in Basic and/or Extended Functions
– If the Extended Functions are used, individual parameters can be traced.
● Test of the SI function "Safe Brake Control" (SBC)
– Required when using Basic and/or Extended Functions
● Test of the SI function "Safe Stop 2" (SS2)
– For this purpose, individual parameters can be traced/recorded.
● Test of the SI function "Safe Operating Stop" (SOS)
– For this purpose, individual parameters can be traced/recorded.
● Test of the SI function "Safely-Limited Speed" (SLS)
– For this purpose, individual parameters can be traced/recorded.
336
Function Manual, 12/2018, 6SL3097-5AR00-0BP1
Safety Integrated