Siemens SINAMICS S120 Function Manual page 336

Acceptance test
7.1 General information about the acceptance test
Authorized persons
Personnel from the machine manufacturer, who, on account of their technical qualifications
and knowledge of the safety functions, are in a position to perform the acceptance test in the
correct manner.
Unwanted motion due to incorrect parameter changes
Incorrect parameter changes for SI functions can result in unwanted motion leading to
death or severe injury.
• After making a change to a parameter for the Safety Integrated Functions, always
• Document the values calculated in an acceptance report.
Unsafe operating states due to manipulation of the Safety Integrated parameters after the
acceptance test
Incorrect parameter changes to Safety Integrated Functions after an acceptance test can
result in unwanted motion resulting in severe injury or death.
• To prevent access to your plants and systems by unauthorized persons, implement
• To avoid incorrect changes to the configuration and parameters of the Safety Integrated
• Check the Safety log book of SINAMICS Safety Integrated at regular intervals. Verify
• If any changes have been made and they are intentional, repeat the acceptance test for
334
WARNING
perform an acceptance test for the function in question.
WARNING
access restrictions and take the precautions described in the security information (see
Chapter "Industrial security (Page 18)" and manual "SINUMERIK/SIMOTION/SINAMICS
Motion Control Industrial Security").
Functions, take the precautions described in this manual.
that no changes have been made to the parameters since the last acceptance test was
performed.
the Safety Integrated Functions affected. The purpose of the acceptance test is to
ensure and document safe operation of the plant. Correct any unintentional changes
back to the original values and repeat the acceptance test.
Function Manual, 12/2018, 6SL3097-5AR00-0BP1
Safety Integrated