Table of Contents
Advertisement
Setting User Account Controls
Because of the security settings inherent in VISTA
and Windows 7, you need to disable the "user
account controls" in the operating system before
uploading START software onto your laptop. Take
the following steps:
In Windows 7:
Go to Start Menu -> Control Panel -> User
Accounts and Family Safety -> User Account ->
Change User Account Control Settings "slide the
slide bar to the lowest value (toward Never Notify),
with description showing Never notify me -> Press
Ok -> Reboot Computer.
In Vista:
Go to the Start Menu type "msconfig" and press
Enter -> In System Configuration select the tools
tab -> Scroll down till you find "Disable UAC"
and single click it -> Press the Launch button ->
Press the Apply button -> Press OK -> Reboot
Computer.
SOFTWARE MAINTENANCE
SDC board software is constantly being enhanced
with new features that create an easier install and
improve on board diagnostic tools. Check the
HySecurity website for atest version of software
before heading out for field maintenance.
Use S.T.A.R.T. software to download latest software
version to a PC laptop and upload it to SlideSmart
gate operator in the field.
NOTICE
If site includes a bi-parting gate system, make
sure software version used in Primary and
Secondary operators is identical.
103
| www.hysecurity.com
ELECTRICAL CONTROLS
No routine maintenance is needed for the
electrical system or controls. If the environment is
very sandy or dusty, or has many insects, be certain
to seal all holes in the electrical enclosure. Blow
the dust out of the electric panel with compressed
air. Use "Smart DC Controller Troubleshooting"
on page 123 to assess and fix error, alert, and
fault codes. If it is necessary to call a distributor
for assistance, be sure to have your model and
serial number ready. Other helpful information
includes the name of the job, approximate date of
installation, and the service record of the operator.
Clock Battery Replacement
A lithium coin battery supports the clock so the
date and time is retained even when the main
power is turned off. Replace the battery about
every five years (or as needed) with a DL 2025, DL
2032, or CR 2025, or CR 2032 battery. See Figure
60.
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
GENERAL MAINTENANCE
CAUTION
Before servicing, turn OFF all power switches.
PHOTO EYE POWER
24 VOLTS COMMON
15
PHOTO EYE POWER
16
DO NOT USE
PHOTO EYE
17
OPEN DIRECTION
18
DO NOT USE
19
PHOTO EYE
CLOSE DIRECTION
20
DO NOT USE
CHARGER
21
AC LOSS
HySecurity
22
LOCK INTERLOCK
MX000585
VERSION
23
S/N
EMERG CLOSE
24
FIRE DEPT OPEN
Smart Touch Controller
LED
LIMIT
DUAL GATE
RADIO OPTIONS
RPM
COM
A
B
COM
OPEN
+24V
Figure 60. Clock Battery Replacement
NO
Lithium Battery
STATUS
+24V
EDGE
COM
MX3640-01 REV. D ©2018
Advertisement
Table of Contents
