Table of Contents
Advertisement
User Menu
Display
RL 1 0 DISABLED
Relay 1 Logic
RL 2 1 CLOSE LIMIT
RELAY 2 LOGIC
RL 3-10 0 CLOSE
LIMIT
Relay 3-10 Logic
TL 2 (45 SECS)
OPEN TIME ALERT
75
| www.hysecurity.com
Table 12. Smart DC Controller - Installer Menu Functions
Setting Options
(Bold = Factory
Settings)
0 = default
1 to 45 available
0 = default
1 to 45 available
0 = Disabled
Up to 45
0 = 0 seconds
1 = 15 seconds
2 = 45 seconds
3 = 75 seconds
4 = 105 seconds
5 = 135 seconds
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
DISPLAY AND MENU OPTIONS
Menu Tasks and Explanations
Configures function of the user 1 output
relay, which is an electromechanical
relay. It has capacity to switch, both
AC and DC and can be used for high
voltage and/or high current loads.
Connect devices directly to the top of
relay: COM plus NO and NC contacts.
Up to 45 optional relay functions exist.
See "Figure 68. Setting the User Relay
Function in the Installer Menu" on page
110.
Configures function of user output relay,
which is an electronic relay with capacity
for switching a DC load only. The User
2 Relay is limited to 48 Volts DC and 4A
maximum load. Up to 45 optional relay
functions exist.
See "Figure 68. Setting the User Relay
Function in the Installer Menu" on page
110.
Similar to Relay 1 Logic.
NOTE: The Hy8Relay™ module option
can be purchased for eight additional
NO relay outputs. Relay #39 set aside
for Factory Use.
Adjusts time delay before activating
a user relay. Maximum time setting is
135 seconds. See "Figure 68. Setting
the User Relay Function in the Installer
Menu" on page 110.
NOTE: This menu controls a user relay
set to Function No. 8
Associated
DC Controller
Display
Connections
User 1 Relay
User 2 Relay
User 3 -10
Relay
User relays
MX3640-01 REV. D ©2018
Advertisement
Table of Contents
