Connecting Dc Power; Using A Solar Powered Operator - HySecurity SwingSmart DC Series Programming And Operations Manual

CONNECTING DC POWER

To connect the DC power:
1. Turn off the DC and AC power switches.
2. Slide the plastic cover off the control box.
3. Attach the red spade connector to the battery
terminal on the DC power switch. See Figure
20.
NOTICE
For extended battery backup installation, refer
to the "Installing the Extended Battery Backup
Kit" on page 50 instructions.
Figure 20. Connecting DC Power
43 | www.hysecurity.com

USING A SOLAR POWERED OPERATOR

HySecurity offers a solar version of the SwingSmart
operator: SwingSmart DCS20. The solar model
has different internal wiring and includes software
programmed for solar use. The Smart DC
Controller has a built-in charger which allows a 24V
solar panel (or two 12V panels) a direct connection
to the SwingSmart operator with no additional
electronic devices required.
To plan a solar-powered site, read through this
entire section. Keep in mind that the SwingSmart
DCS 20 operator does not have the following
components:
z Transformer
z AC power supply board
z AC service outlet
z Various wiring adaptations that are standard in
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
NOTICE
Solar panels are NOT included in the purchase
of the SwingSmart DCS 20 Solar operator. Also,
adapting a standard SwingSmart DC operator
to a solar application is not recommended. For
ease of installation and proper functionality,
be sure to order a SwingSmart DCS 20 for a
solar-powered site.
a SwingSmart DC 20 operator
POWER
MX3640-01 REV. D ©2018