Enabling Fire Department Override - HySecurity SwingSmart DC Series Programming And Operations Manual

ENABLING FIRE DEPARTMENT OVERRIDE

Many counties and cities require a Fire Department
override system for gate operators. The fire
department's alert system is a separate unit that
must be connected to the Smart DC Controller.
FIRE DEPARTMENT OPEN option must be
properly configured through Installer Menu before
operator will recognize alert system.
To enable Fire Department Override, take
following steps and see Figure 42 and Figure 43:
1. Connect NO contact from alert system or
key switch to following Smart DC Controller
terminals: EMERG OPEN and +24V.
2. Configure Installer Menu. At a gate status
display, press MENU button twice. This
accesses User Menu and CLOSE TIMER display
appears.
3. Simultaneously, press OPEN and RESET
buttons to enter Installer Menu. Release
buttons and USAGE CLASS display appears.
It is first item in Installer Menu.
4. Press NEXT until FIRE DEPARTMENT OPEN
display appears. Factory default setting is 0.
5. Use NEXT button to change number on display
to 1 and then press SELECT.
6. To exit Installer Menu, press MENU button.
Gate status appears in display indicating you
have returned to Run Mode.
FIRE
Figure 42. Fire Department Override Wiring
79 | www.hysecurity.com
COM
STOP
OPEN
CLOSE
OPEN
P ARTIAL
SENSOR 2
SENSOR 3
EXIT
LOOP
BLOCK
EXIT
IN OBS
LOOP
OUT OBS
LOOP
CENTER
LOOP
SENSOR 1
SENSOR
COM
+ 24 V
EMERG
OPEN
SHOW
LEDs
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
DISPLAY AND MENU OPTIONS
HYSECURITY
GATE CLOSED
OPEN CLOSE STOP
PREV NEXT SELECT
CT 0 (OFF)
CLOSE TIMER
OPEN CLOSE STOP
NEXT SELECT
PREV
LL 0 (OFF)
LEARN LIMIT
OPEN CLOSE STOP
PREV NEXT SELECT
FO 1
FIRE DEPT OPEN
OPEN CLOSE STOP
NEXT SELECT
PREV
Figure 43. Fire Department Override Commands
1. Start at a gate
status display.
MENU RESET
2. To access the
User Menu,
press the MENU
button twice.
MENU RESET
3. Access the
Installer Menu, by
simultaneously,
pressing the
OPEN and
RESET
buttons.
MENU RESET
4. Use NEXT to
navigate to the
menu display.
Change the
setting using the
SELECT and
MENU RESET NEXT buttons.
MX3640-01 REV. D ©2018