HySecurity SwingSmart DC Series Programming And Operations Manual page 131

Display
Condition
ALERT 28
BATTERY
DISCONNECTED
FAULT 2
PHOTO EYE
FAULT 3
VOLTAGE SAG
FAULT 4
GATE NO LOAD
FAULT 5
LIMIT FAILED
FAULT 14
STUCK GATE
ERROR 1
DIRECTION
ERROR
131 | www.hysecurity.com
Table 22. Smart DC Controller - Troubleshooting
Description
Alert, Error or
Fault
Dead or disconnected batteries
Battery detected by SDC board. Operator
Disconnected may still be functional if on AC power
from Board but will not have battery backup. Was
Error 9 in pre-h5.57 software versions
This fault can only occur if monitored
P h o t o e y e i s
photo eye check fails. See "Monitored
missing or not
External Entrapment Sensors" on page
working.
118 for details.
Not used in
Caused by inadequate supply wire size
SwingSmart.
Smart DC
Possible causes:
Controller has
detected there
z Motor wires disconnected.
is no load on
z DC switch off.
operator. Gate is
z Linkage failure
non-operational
while this fault is
z Taper clamp being too loose
triggered.
Not used with
Not used with DC operators
DC operators
Smart DC
Controller
tries 3 times to
overcome stuck Caused by broken gate hardware or
gate. Gate is ice/snow buildup.
non-operational
while this fault is
triggered.
S m a r t D C
z Motor wiring.
Controller detects
operator ran in
z Limit switch wiring (SwingSmart DC)
wrong direction.
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
Possible Causes
REFERENCE
Solutions
Replace or reconnect
batteries to the
controller.
Correct malfunctioning
photo eye.
Correct wire size to AC
supply
1. Check DC motor
wires.
2. Replace drive belt.
3. Turn DC power
switch on.
4. Tighten taper
clamp.
5. Press RESET to
clear fault.
Not used with DC
operators
1. Check and correct
gate hardware as
required.
2. Press RESET to
clear fault.
1. Check motor
wiring and correct,
as needed.
2. Press RESET to
clear fault.
MX3640-01 REV. D ©2018