HySecurity SlideSmart DC User Manual

HySecurity SlideSmart DC User Manual

Hide thumbs Also See for SlideSmart DC:

Advertisement

Quick Links

Quick Start Steps

Keyed latch
Cover
W
Operator
Unpack
1
the Operator

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SlideSmart DC and is the answer not in the manual?

Questions and answers

Summary of Contents for HySecurity SlideSmart DC

  • Page 1 Quick Start Steps Keyed latch Cover Operator Unpack the Operator...
  • Page 2 Public Side WARNING t ZE/E' & Attach WARNING Signs & Secure Side Site Overview SlideSmart Operators SlideSmart DC 10F SlideSmart DC 15 Duty cycle: Duty cycle: Power, Single phase: ^ Power, Single phase: ^ Motor: Motor: Maximum gate weight: Maximum gate weight:...
  • Page 3 Operator & Earth Ground Installation Concrete Pad Dimensions Mount the Operator Gate Gate to base mounts Chain to Gate Gate Area cut out height conduit 6.9 x 12 Side View NOTE: K operator Side Cut-away View shows conduit placement & grounding Ground Ground wire...
  • Page 4 Install the Chain Pedestrian gate Front edge Public Side of gate Trailing edge of gate Secure Side Install the bolt Chain Brackets 1. Measure for proper chain alignment BEFORE welding the Chain bracket brackets to the gate. Make sure the chain will run horizontal to the ground and parallel with Install and Align the Chain the gate.
  • Page 5 SH 0 GATE HANDING > OPEN CLOSE STOP MENU RESET PREV NEXT SELECT > / ^>d/KE^ WT 0 GATE WEIGHT (LB) SlideSmart DC 15 SlideSmart DC 10F < < OPEN CLOSE STOP MENU RESET < < < < NEXT SELECT PREV <...
  • Page 6 Install the Target Magnet Public Side Pedestrian gate With the gate in the &h>> >K^ mark the chain link the target sensor. Use the target sensor closest to the the gate. Secure Side To install the target magnet, take the following steps: To install the target magnet KWE ^dKW...
  • Page 7 Turn OFF Main Power and Control Box Switches, then Connect AC Power Turn Power OFF Turn OFF AC power at the source DANGER (circuit breaker panel) before & > Make sure both the DC and AC power switches K&& Place the power switches in the K&&...
  • Page 8: Radio Receiver

    Œ EYE COM EMERG Œ Z OPEN Œ EYE OPEN or CLOSE - SHOW LEDs USB PORT RS-485 USER RELAY 2 COMMUNICATION 2 channel Solid state radio receiver Edge & SlideSmart DC sensor Page 8 www.hysecurity.com © 2010 HySecurity® D0349 Rev. B...

Table of Contents