HySecurity SwingSmart DC Series Programming And Operations Manual page 86

Smart DC Terminal
UL 325 - 2016
Exit Loop
Block Exit
Inside Obstruction
Loop
Outside Obstruction
Loop
Center Loop
Sensor 1
Sensor COM
+24V
86 | www.hysecurity.com
Table 13. SDC Controller Inputs
Smart DC Terminal
pre-2016
Exit Loop
Block Free Exit vehicle
detector or Close Timer
Inside Obstruction
Vehicle Detector
Outside Obstruction
Vehicle Detector
Center Loop (Shadow)
Vehicle Detector
Edge Sensor
Eye Common
- 24 Volts Common
+24V
SWINGSMART DC PROGRAMMING AND OPERATIONS MANUAL
SMART DC CONTROLLER
Wire Connections
N.O. input. Connection
for free exit vehicle
detector.
N.O. input.
N.O. input.
N.O. input.
N.O. input.
Type of sensor used
is programmable in
Installer Menu (S1).
All devices used for
external entrapment
protection that require
monitoring must be
connected to SENSOR
COM.
Convenient 24VDC
power
Comonly used for...
Free Exit Vehicle
Detector
Free Exit is only
disabled if Close Limit
Switch is tripped. If
the gate is partially
opened, the Free Exit
detector will trigger the
gate to open fully. The
input can be converted
in the Installer Menu
(menu item DT) to
alternately disable the
Close Timer.
Inside reversing loop.
Optional settings
available: Installer
Menu item IR.
Inside reversing loop.
Optional settings
available: Installer
Menu item IR.
Shadow function
used for Swing gates.
Optional settings
available: Installer
Menu item HD.
Device common power.
Connect external
entrapment protection
sensors to these
terminals.
Convenient 24VDC
power for photo eyes
or the Emergency
Open input.
MX3640-01 REV. D ©2018