Safety Protection Device
1.
Disconnect the battery negative cable and wait for 90s.
Refer to
2.
Remove the center upper pillar trim panel. Refer to
12.9.1.4 Center Pillar Trim Panel
3.
Disconnect the side collision sensor harness connector.
4.
Remove the side collision sensor retaining bolts and
remove the sensor.
Installation Procedure:
1.
Install the side collision sensor and tighten the retaining
bolts.
Torque: 8 Nm (Metric) 5.9 lb-ft (US English)
2.
Connect the side collision sensor harness connector.
3.
Install the center upper pillar trim panel.
4.
Connect the battery negative cable.
FE09-0044b
9.2.7.8
Replacement
Refer to
procedure.
9.2.7.9 Side Airbag Replacement
Note
If the side airbag has been deployed, please replace the
front seat back.
Airbag System
2.11.8.1 Battery
Disconnection.
Passenger
Recognition
11.11.8.6 Electric Seat Cushion
EC718/EC718RV EC715/EC715RV 10/2009
9-41
Replacement.
Sensor
Replacementremoval