Siemens SINAMICS S120 Function Manual page 509

7. The "I/O address" column displays the start address for every DO.
8. The "Data Exchange Broadcast - Overview" tab shows you the configured slave-to-slave
Drive functions
Function Manual, (FH1), 10/2008, 6SL3097-2AB00-0BP5
Select the start address of the data of the DO to be read. This is 268 in the example.
If the complete data of the Publisher are not read, set this via the "Length" column. You
may also offset the start address for the request so that data can be read out in the
middle of the DO telegram.
Figure 10-34 Configuring the slave-to-slave communication nodes
communication relationships which correspond to the current status of the configuration
in HW Config.
Figure 10-35 Data Exchange Broadcast - Overview
Communication PROFIBUS DP/PROFINET IO
10.2 Communication via PROFIBUS DP
509