Siemens SINAMICS S120 Function Manual page 441

Bit Meaning
2 Operation enabled
3 Fault active
4 Coasting active (OFF2)
5 Quick stop active (OFF3)
6 Switching on inhibited
7 Alarm present
8 Speed
setpoint-actual value deviation
within tolerance band
9 Control request to PLC
10 f or n comparison value reached or
exceeded
Drive functions
Function Manual, (FH1), 10/2008, 6SL3097-2AB00-0BP5
1 Operation enabled
Enable electronics and pulses, then ramp up to
active setpoint.
0 Operation inhibited
1 Fault active
The drive is faulty and, therefore, out of service.
The drive switches to "switching on inhibited" once
the fault has been acknowledged and the cause
has been remedied.
The active faults are stored in the fault buffer.
0 No fault present
No active fault in the fault buffer.
1 No OFF2 active
0 Coasting active (OFF2)
An OFF2 command is active.
1 No OFF3 active
0 Quick stop active (OFF3)
An OFF3 command is active.
1 Switching on inhibited
A restart is only possible by means of OFF1 and
then ON.
0 No "switching on inhibited"
Power-up is possible.
1 Alarm present
The drive is operational again. No
acknowledgement necessary.
The active alarms are stored in the alarm buffer.
0 No alarm present
No active alarm in the alarm buffer.
1 Setpoint-actual value monitoring within tolerance
band
Actual value within a tolerance band; dynamic
overshoot or undershoot for t < t
e.g.
n = n ±
set
f = f ±, etc.,
set
t can be parameterized
max
0 Setpoint/actual value monitoring not within
tolerance band
1 Control requested
The PLC is requested to assume control. Condition
for applications with isochronous mode: drive
synchronized with PLC system.
0 Local operation
Control only possible on device
1 f or n comparison value reached or exceeded.
0 f or n comparison value not reached.
Communication PROFIBUS DP/PROFINET IO
10.1 Communication according to PROFIdrive
Remarks
permissible,
max
BICO
BO: r0899.2
BO: r2139.3
BO: r0899.4
BO: r0899.5
BO: r0899.6
BO: r2139.7
BO: r2197.7
BO: r0899.9
BO: r2199.1
441