Omron R88M-W60010T User Manual page 337

Troubleshooting
• If using Computer Monitor Software, transfer all of the parameters saved in the host to the Ser-
vo Driver. Refer to the manuals for the host for operating procedures.
4.Set up the absolute encoder (ABS).
• If using a Servomotor with an absolute encoder, when replacing the Servomotor, the absolute
data in the absolute encoder will be cleared, so you need to reset the data. Also, the multi-turn
data will be different from before the Servo Driver was replaced. If the host device is a CS1W-
MCH71 or CJ1W-MCH71, make the initial settings for the host device.
Note Refer to 4-2-2 Absolute Encoder Setup and Battery Changes for details.
Chapter 5
5-5