Omron R88M-W60010T User Manual page 225

Operation
Pn50B.3 Input signal selections 2 -- Not used.
Setting ---
range
Note Do not change setting.
Pn511.0 Input signal selections 5 -- DEC (origin return deceleration LS) signal input terminal allocation
(All operation modes)
Setting 0 to F
range
• Settings are the same as for Pn50A.3.
• When "7" (always enabled) is set, the deceleration switch is always enabled.
• When "8" (always disabled) is set, the deceleration switch is always disabled.
Pn511.1 Input signal selections 5 -- EXT1 (external latch signal 1) signal input terminal allocation (All
operation modes)
Setting 0 to F
range
Setting Explanation
Setting
0 to 3 Always OFF
4 Allocated to CN1-10 pin: enabled using L input
5 Allocated to CN1-11 pin: enabled using L input
6 Allocated to CN1-12 pin: enabled using L input
7 Always ON
8 Always OFF
9 to C Always OFF
D Allocated to CN1-10 pin: enabled using H input
E Allocated to CN1-11 pin: enabled using H input
F Allocated to CN1-12 pin: enabled using H input
• When "7" (always enabled) is set, the external latch signal is always enabled.
• When "8" (always disabled) is set, the external latch signal is always disabled.
Pn511.2 Input signal selections 5 -- EXT2 (external latch signal 2) signal input terminal allocation (All
operation modes)
Setting 0 to F
range
• Settings are the same as for Pn511.1.
• When "7" (always enabled) is set, the deceleration switch is always enabled.
• When "0 to 3" or "8 to C" (always disabled) is set, the deceleration switch is always disabled.
Pn511.3 Input signal selections 5 -- EXT3 (external latch signal 3) signal input terminal allocation (All
operation modes)
Setting 0 to F
range
Unit ---
Unit ---
Unit ---
Unit ---
Unit ---
Default 8
setting
Default 3
setting
Default 4
setting
Explanation
Default 5
setting
Default 6
setting
Chapter 4
Restart Yes
power?
Restart Yes
power?
Restart Yes
power?
Restart Yes
power?
Restart Yes
power?
4-29