Removing And Replacing Tier 1 Crus; Removing The Blade Server Cover - IBM BladeCenter JS22 Problem Determination And Service Manual

If you have changed the configuration of the blade server or if this is a different
blade server than the one you removed, you must configure the blade server. You
might also have to install the blade server operating system.
See the "Installing the operating system" in the online information or the
Installation and User's Guide PDF for detailed information about these tasks.

Removing and replacing Tier 1 CRUs

Replacement of Tier 1 customer-replaceable units (CRUs) is your responsibility.
If IBM installs a Tier 1 CRU at your request, you will be charged for the
installation.
The illustrations in this documentation might differ slightly from your hardware.

Removing the blade server cover

Remove the blade server from the chassis unit and press the blade server cover
releases to open and remove the blade server cover.
Blade-cover
release
Figure 8. Removing the cover
Perform the following procedure to open and remove the blade server cover.
1. Read "Safety" on page v and the "Installation guidelines" on page 237.
2. Shut down the operating system, turn off the blade server, and remove the
242
JS22 Type 7998: Problem Determination and Service Guide
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 239.
Cover
pins
Blade-cover
release