Using Protocol Macros 6 - Omron CJ1W-SCU32 Operation Manual

Manual Configuration
Sysmac Studio Version 1 Operation Manual (Cat. No. W504)
Section
Section 1
Introduction
Section 2
Installation and Uninstallation
Section 3
System Design
Section 4
Programming
Section 5
Online Connections to a Controller
Section 6
Debugging
Section 7
Other Functions
Section 8
Reusing Programming
Section 9
Support Software Provided with the
Sysmac Studio
Section 10
Troubleshooting
Appendices
CJ-series Serial Communications Units Operation Manual for NJ-
series CPU Unit (Cat. No. W494) (this manual)
Section
Section 1
Introduction
Section 2
Initial Settings and Allocations of
Device Variables for CJ-series Unit
Section 3
Installation and Wiring
Section 4
Using Protocol Macros
Section 5
Serial Gateway
Section 6
No-protocol Mode
Section 7
Using Modbus-RTU Slave Mode
Section 8
Loopback Test
Section 9
Troubleshooting and Maintenance
Reference
Appendix
4
This section provides an overview and lists the specifications of the Sysmac Studio
and describes its features and components.
This section describes how to install and uninstall the Sysmac Studio.
This section describes the basic concepts for designing an NJ-series System with the
Sysmac Studio and the basic operating procedures.
This section describes how to create programs with the Sysmac Studio.
This section describes how to go online with a Controller.
This section describes how to debug the programs online on the Controller or debug
it offline with the Simulator.
This section describes other functions that are supported by the Sysmac Studio,
including security functions and troubleshooting functions.
This section describes how to reuse the programs that you create with the Sysmac
Studio.
This section describes the Support Software that is provided with the Sysmac Studio.
This section describes the error messages that are displayed when you check a pro-
gram on the Sysmac Studio and how to correct those errors.
The appendices describe the following:
Driver Installation for Direct USB Cable Connection
Specifying One of Multiple Ethernet Interface Cards
Online Help
Simulation Instructions
This section provides an introduction to the Serial Communications Units and their
features. It also describes the operating procedure and the specifications of the
Serial Communications Units.
This section describes the data exchange between the CPU Unit and Serial Commu-
nications Unit and the definitions of the device variables for CJ-series Unit.
This section describes where and how to install the Serial Communications Unit, and
how to connect and wire them.
This section describes the protocol macro function provided by the Serial Communi-
cations Unit and the procedure for using the function.
This section describes the Serial Gateway function provided by the Serial Communi-
cations Unit and the procedure for using the function.
This section describes the No-protocol Mode function provided by the Serial Commu-
nications Unit to send/receive data, and the procedure for using the function.
This section describes the Modbus-RTU Slave Mode function provided by the Serial
Communications Unit, the procedure for using the function and the details of the
command responses.
This section describes the loopback test function provided by the Serial Communica-
tions Unit and the procedure for using the function.
This section describes the troubleshooting procedure, event logs and maintenance
procedure for the Serial Communications Unit.
This section describes the details on the standard system protocols provided by the
CX-Protocol and the Serial Communications Unit.
---
CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)
Description
Description