Omron CJ1W-SCU32 Operation Manual page 455

The following command is set in the words specified by the 3rd operand of PMCR(260).
ATE0V0X4\V2\N3%C0*C0\X1&M0S26=10
0012 0020
Additional Information
Turn ON pin 4 of DIP switches SW3 for this Modem (ER signal always ON).
MD144FB5V (OMRON, No longer manufactured.)
The following command is set in the words specified by the second operand of PMCR(260).
ATE0V0X4\V2\N3%C0*C0\Q0&M0&D0%B9600S26=10
0017 0029
ME1414BIII/ME2814BII (OMRON)
The following command is set in the words specified by the second operand of PMCR(260).
AT\J1B8E0V0S0=1X4\V2\N3&M0%C0&D0&E0\X1S26=10
0018 002C
Additional Information
Turn ON DIP switch SW3 in the rear of the Modem.
Dial (Sequences No. 561 (Hex 0231), No. 571 (Hex 023B), and
No. 581 (Hex 0245))
To dial a telephone numbers for the OMRON ME1414BIII/ME2814BII Modems using sequences No.
561, 571, 581, set the dialling command and telephone number in the words specified by the 3rd oper-
and of PMCR(260). However, for other Modems, make the following settings for the sequence No. 553,
Data Send/Receive (general purpose sequence).
This is an example of telephone number settings for the above mentioned 4 OMRON Modems.
CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)
A T E 0 V 0 X 4 \ V 2 \ N 3 % C 0 * C 0 \ X 1 & M 0 S 2 6 = 1 0
Character string length of modem initialization command (bytes)
Code length of PMCR(260) when it is used (words)
A T E 0 V 0 X 4 \ V 2 \ N 3 % C 0 * C 0 \ Q 0 & M 0 & D 0 % B 9
Character string length of modem initialization command (bytes)
Code length of PMCR(260) when it is used (words)
A T \ J 1 B 8 E 0 V 0 S 0 = 1 X 4 \ V 2 \ N 3 & M 0 % C 0 & D 0
Character string length of modem initialization command (bytes)
Code length of PMCR(260) when it is used (words)
A Standard System Protocol
6 0 0 S 2 6 = 1 0
& E 0 \ X 1 S 2 6 = 1 0
R-121