Omron CJ1W-SCU32 Operation Manual page 165

Device vari-
Name able for CJ-
series Unit
Local Unit *_P1_LclBusyS
Busy ta
*_P2_LclBusyS
ta
Transmission [ER]
Control Sig- *_P1_SigERSta
nal Status *_P2_SigERSta
[DR]
*_P1_SigDRSta
*_P2_SigDRSta
[CS]
*_P1_SigCSSta
*_P2_SigCSSta
[RS]
*_P1_SigRSSta
*_P2_SigRSSta
Transmission *_P1_TransErr
Error Status Sta
*_P2_TransErr
Sta
CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)
Meaning
This variable indicates the receive status
of the Local Unit (Unit) during Recv when
Xon/Xoff flow control is set in the transmis-
sion control parameters.
TRUE: Local Unit busy (Reception is dis-
abled because the reception buffer is more
than 4/5 (= 2 K bytes or more).)
FALSE: Local Unit ready to receive
(Reception is enabled because the recep-
tion buffer is less than 1/5 (= 0.5 K bytes or
less).)
This area is cleared when the Controller is
reset, at port restart by the Port Settings
changing flags (Auxiliary Area), or when
the next sequence is started.
The status of each transmission control
signal (DTR (ER), DSR (DR), CTS (CS),
RTS (RS)) for each port is always read.
TRUE: High, FALSE: Low
When an error occurs during transmission,
the corresponding flag (in bits 02 to 07 or
12 to 15) changes to TRUE.
The number of retries is stored in bits 08
to 11.
Note 1 The Transmission Error Flag (bit
15) changes to TRUE only when
the protocol macro has moved to
error processing due to an error in
bits 00 to 14.
2 The number of retries in bits 08 to
11 is not equal to the number of
times processing is performed
when an error occurs. It is the set
number of retries.
When communications are restored by
protocol macro retry processing, the error
in bits 02 to 07 or 12 to 15 is stored. The
Transmission Error Flag (bit 15), however,
will remain FALSE.
If another error occurs during retry pro-
cessing, the status of the bit that indicates
the cause is held.
4 Using Protocol Macros
Timing
Initialize Set
Controller When status
reset (*) is read
When status
is read
At error
Reset
After busy
status is
released
When status
is read
4
When
sequence
begins
4-29