Omron CJ1W-SCU32 Operation Manual page 434

A Standard System Protocol
Memory Switch Set 1 (3000-series, High-speed Type)
(Sequence No. 421 (Hex 01A5))
This sequence sets memory switches.
Send Data Word Allocation (3rd Operand of PMCR(260))
First word of send
data
Offset
+0 Number of send data words
(4 digits Hex)
+1 w (1 digits BCD)
x (1 digit BCD)
y (1 digit BCD)
z (1 digit BCD)
+2 v (1 digit BCD)
Note Settings marked with asterisks are required for this protocol.
Receive Data Word Allocation (4th Operand of PMCR(260))
None.
Additional Information
• Memory switches cannot be set when DIP switch SW3, pin 5 of the Laser Micrometer is not
turned ON.
• The setting (y, z) of RS-232C takes effect when the power supply is turned back ON.
R-100
+0 Number of send data words
+1
W X Y
+2
(Undefined)
Contents
(data format)
CJ-series Serial Communications Units Operation Manual for NJ-series CPU Unit(W494)
Z
V
0003 (fixed)
0: For single run or zero run measurement start displaying '---.'
1: For single run or zero run measurement start displaying the
previous measured value
0: Perform single run measurement to the RUN signal of I/O IF
1: Repeat measurement while the RUN signal of I/O IF is input
*0: RS-232C Delimiter CR+LF
1: RS-232C Delimiter CR
2: RS-232C Delimiter LF
0: RS-232C no parity check
1: RS-232C odd parity check
2: RS-232C even parity check
0: Displaying 'Err-0'
1: Displaying '0'
Data